Alisun

For T-stand Alisun Expression | Allura | Ambiance | Desire | Sunstar. TL = 487mm. Used for T-stand with 8 adjustment holes in the stand.

Gas spring for Alisun E10, E12 and Expression 10 on G-stand.

Overlay foil for Alisun NL2 control board

Replacement gas spring Alisun Q-Vision 450N Length excluding thread: 700mm Stroke: 208mm Color: Galvanized Strength: 450N

Replacement 335N gas spring for the Alisun 1000H TD. This canopy is factory fitted with 1x 260N and 1x 410N gas spring.

Replacement gas spring for the Alisun G-tripod with 8 holes at the bottom Spring excluding screw thread: 362mm Stroke: 152mm Color: High-gloss galvanized Number of the original Alisun gas spring was 346181 Comes without mounting material

Display PCB complete with connection cable for the Sunvision V200 series. Two LED digits

Replacement gas spring for the original 19-200 525 G WG 400N gas spring. Delivered without the transferable mounting pieces

replacement gas spring for a series of Sunvision models. See the information tab on the detail page. DOMOR 95-167-403/2100N.

Gas spring used for combi model Alisun E34 plus

Gas spring used for Alisun Allura, Expression ( XL) and other Alisun sunbeds were 300N gas springs were fitted.

Endcap for the models: Allura, Ambiance, Expression, Desire and Sunstar. This is an original Alisun part. Only available in the color as shown. Useable for canopy and sunbed, right and left.

For Alisun SALSA models produced up to 2004. This means: Models with serial numbers less than 0433909. Higher serial numbers need the 220N or 240N version.

For Alisun 1000KS (KS = Canopy + Bench). 1000H +1000B combi with 20 lamps. TL = 449mm

Gas spring for Alisun E10 and E12 on G-stand. EGS10 and EGS12

Gas spring for Alisun E10 on G-stand. EGS10 Before type HOLOR92

For Alisun 700S on tripod with one gas spring Total spring center to center mounting points: about 52cm Length (L in the picture) excluding m8 screw thread: 460mm = 46cm