Timer 30 min. Hapro Jade new version

Original Hapro

Type HX6854 A

This timer works with a overrule-print (a separate PCB)
In case of a defective timer, the overrule-PCB must always be replaced.
If an overrule-print has detected more than 5 faults in a row, it will no longer resets and therefore will never work again! In that case , if you switch on the solarium, after a few seconds you hear a beep and the solarium switches off.
In that case both timer and overrule print have to be replaced!

Note that the acrylic plate of the canopy NEVER touches the axis of the timer.This is the most common cause of defective timers and overrule-prints! Hapro has modified this from 2012 on, so with newer models this is no problem anymore.

Instruction manual (Dutch) for replacement